TES Skyrim SE 0.415

[Anubis]

Sorry - used c8220 - replied and then saw your comment. (did not refresh before)



I'll try again with correct weather code.

[Anubis]

Ok, tried with fw 10a234


Very hard to get a screenshots, because after few seconds with this weather it went to


Effect switched off with weather fw 10a234
Using fw c8220 1 enabled it again.

[Anubis]

Had to use fw c8220 1

With fw 10a234 everything is like this

[ENBSeries]

I do not see any problem with any of screenshots you did, investigated all factors which output result and reflection is visible for you. Also this effect is immune to weather, unless you have weather system enabled or locations for wet effects, this is very suspicious behavior. Try attached, 0.5 and 1.5. At 0.5 it should have very intense effect. With 1.5 it must give red color. Check if some of those weathers turn red off and if it is, you must have reflectionamount*** set to 0, there is no other way to make it off.

EDIT: file deleted

[Anubis]

used fw 10a234


You were right - I used the default files that come with the latest version - reflection was 0 in Wetsurfaces and 0.3 in Rainwetsurfaces. I set them all to 1 and the effect was visible again.

But this does not explain why fw c8220 1 had the effect visible even with reflection 0


I have no weather system or any weather mods installed.

[ENBSeries]

If c8220 weather have rain, then it's answer why effect activates. So, effect do work for you, but the setting are too low, so you barely see it. There is no issue.

[Anubis]

But when I played the game with rainy weather I did not see any wet effects, even if I changed these settings.

[ENBSeries]

In last version i just multiplied 10 times output. So it's non of my business.

[Arindel]

@Anubis:
Are you waiting 30 seconds when switching between rainy and non-rainy weathers? Remember, there's a transition time which takes about 30 seconds. Maybe that's why you think it's not working. The effect simply hasn't fully transitioned from [WETSURFACES] to [RAINWETSURFACES]. [RAINWETSURFACES] and [WETSURFACES] don't take effect instantly when changing weathers using FW console command.

For me it's working perfectly with all the vanilla rainy weathers. It just takes a bit of time for [RAINWETSURFACES] to start. The opposite is also true. If you instantly switch from rainy to clear weather, the [RAINWETSURFACES] is still in effect for 30s while transitioning into [WETSURFACES].

[Anubis]

I know about the waiting time - I have set it to 5 sec.

Can you upload some screenshots without the effect and with the effect (with rainy weather) ?